Sparrow Fabrications

FDM 3D Printed Camera Accessories made in the U.K.

Cosina CX2 Shutter Release Cable and Filter Adapter

SKU: SF-CX2-SRF

Cosina CX2 Shutter Release Cable and Filter Adapter. Please note the cable required is shown but not included. Works with cables such as this one. Camera shown is not included. Also, note the step up ring required is shown but not included. Requires a 25mm step up ring to suit whatever filters you wish to use.

Designed by me from scratch to fit the Cosina CX2 camera. It allows you to use a shutter release cable and filters.

The adapter hooks onto the left-hand side of the camera and is held in place on the right-hand side by a sliding retainer, so no tools are needed to fit or remove it.

This adapter uses a linear threaded nut to hold the shutter release cable so it is best not to screw the cable in too tight unless you don’t plan on removing it again.

Directions for use

To use with a cable, push fit the cable anchor onto the main body of the adapter and screw the release cable in through the top as shown.

To use with a filter, gently screw or push a 25mm step up ring into the front of the adapter.

Then, to fit the adapter to the camera:

  1. Rotate the camera’s lens mount clockwise to open the lens cap.
  2. Hook the left-hand side of the adapter onto the camera.
  3. Whilst pressing the right-hand side of the adapter onto the lens mount, slide the retainer behind it to hold the adapter on the camera.

To remove the adapter, follow these steps in reverse.

Supported Cameras

Tested with:

Installation Video

Product Images